3DR Radio Telemetry 500MW 433Mhz or 915Mhz Air and Ground Data


$5.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
Independent signal amplifier 1W $140
Same design, both modules can be used either on the groundstation or in the air
Both come with Micro USB TTL port
Equips with 3 kinds of cable for APM and Pixhawk(5P for Apm,6P for Pixhawk) OTG
Use a small omnidirectional antenna up to several kilometers
Bidirectional amplifiers available for greater range
Open source firmware
Product Details
Frequency:433MHZ or 915Mhz
Antenna connectors: RP-SMA connector
Power: 500mw
Sensitivity: -118dBm sensitivity
Interface: Standard TTL UART
Connection status: LED indicators
Net weight: 63g
RadioTelemetry Air Module Dimension: 51*30*10mm/12g
RadioTelemetry Ground Module Dimension: 70*25*12mm/15g
QA-433MHZ-500MW
3DR Radio Telemetry 500MW 433Mhz or 915Mhz Air and Ground Data Transmit Module For APM 2.6 2.8 Pixhawk Flight Control
3DR Radio Telemetry 500MW 433Mhz or 915Mhz Air and Ground Data Transmit Module For APM 2.6 2.8 Pixhawk Flight Control
3DR Radio Telemetry 500MW 433Mhz or 915Mhz Air and Ground Data Transmit Module For APM 2.6 2.8 Pixhawk Flight Control
3DR Radio Telemetry 500MW 433Mhz or 915Mhz Air and Ground Data Transmit Module For APM 2.6 2.8 Pixhawk Flight Control
3DR Radio Telemetry 500MW 433Mhz or 915Mhz Air and Ground Data Transmit Module For APM 2.6 2.8 Pixhawk Flight Control
3DR Radio Telemetry 500MW 433Mhz or 915Mhz Air and Ground Data Transmit Module For APM 2.6 2.8 Pixhawk Flight Control
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

Product 5/240

 Prev 
 All 
 Next 

This product was added to our catalog on Friday 17 December, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here