AIO F3 V1.1 Flight Controller with Integrated OSD Barometer

$34.99  $34.00
Save: 3% off

Add to Cart:

  • Description
  • Details
  • Reviews
  • Custom Tab
A new generation AIO Flight control for FPV
Based on F303 MCU, using F3 MCU controls OSD over SPI bus in DMA mode
OSD Configuration has been incl. in Betaflight GUI.
Supports SD Card and LIPO direct input (2-4S)
MPU6000 at SPI bus.
4 in 1 Integraded ESC ports
Product Details
STM32 F303 MCU, Runs Betaflight 3.0 firmware
SBUS/PPM input (Pin headers)
8PWM output (1-4Pinheaders and Sh1.0 Plug, 5-6 as Pin headers)
128Mb Flash(16M Byte)
optional Barometer BMP280, you can close it by software.
SPI Sensor MPU6000
Item: F3 FC
LiPo Input: 2-4S
Support SD card
Size: 36x36mm
Mount Holes: 30.5x30.5mm
AIO Flight control
AIO Flight control
AIO Flight control
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

This product was added to our catalog on Monday 26 September, 2016.



Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.

your alt text here