Benewake TF03-180 Lidar IP67 180m Long-range Distance Laser


$430.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
TF03 is a industrial high-speed LiDAR, It contains two versions with 100m and 180m.
TF03 includes compensation algorithms for outdoor glare and other interference,
so it works normally under strong light environment and rain, fog and snow conditions.
Different built-in operating modes let customers change parameters and configuration
to meet their need. The product is applicable to the terrain following of drones,
the collision avoidance of cars, intelligent transportation and industrial safety warning.
Product Details
Product performance
- Operating range:0.1m-180m@90% reflectivity;0.1m-70m@10% reflectivity;
0.1m-130m@90% reflectivity&100Klux;0.1m-50m@10% reflectivity&100Klux
- Accuracy:±10cm (within 10m), 1% (10m and further)
- Distance resolution:1cm
- Frame rate:1Hz~1000Hz adjustable (default 100Hz)
- Ambient light immunity:100Klux
- Operation temperature:-25~60?
- Enclose rating:IP67
Optical parameters
- Light source:LD
- Central wavelength:905nm
- Photobiological safety:CLASS1(EN60825)
- FOV:0.5°
Electrical parameters
- Supply voltage:5V
- Average current:=180mA
- Power consumption:=0.9W
- Communication level:LVTTL(3.3V)
- Communication interface:UART/CAN/IO
Item Packing
Benewake IP67 180m Distance Lidar x 1
TF03-180
Benewake TF03-180 Lidar IP67 180m Long-range Distance Laser Sensor Support UART Communication Interface
Benewake TF03-180 Lidar IP67 180m Long-range Distance Laser Sensor Support UART Communication Interface
Benewake TF03-180 Lidar IP67 180m Long-range Distance Laser Sensor Support UART Communication Interface
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

Product 28/240

 Prev 
 All 
 Next 

This product was added to our catalog on Thursday 07 April, 2022.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here