CAN PMU Power Module CUAV High Precision Power Detection Module


$120.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
CUAV CAN PMU Power Module High Precision Power Detection Unit Module For UAV And Flight Controller
CAN PMU is a drone power management unit with a built-in STM32F4 processor and running the
CUAV ITT algorithm. It can accurately measure the drone voltage and current in real time.
It supports a maximum of 6-62V voltage and 110A current and can output 5.4V 5A.
(Maximum instantaneous 8A / 120s, constant 5A) Powers the flight controller, uses CAN bus
communication, supports standard UAV CAN protocol, and each PMU unit is factory
calibrated to ensure good consistency and high accuracy.
Product Details
Processor:STM32F412 100Mhz 512K Flash 256K RAM
Voltage input:6-62V(2-15S)
Max current:110A
Voltage accuracy:±0.05V
Current accuracy:±0.1A
Resolution:0.01A/V
Max output power:6000W/90S
Max stable power:5000W
Power port output:5.4V/5A
Protocol:UAVCAN
Operating temp:-20℃ ~ +100℃
Firmware upgrade:Support
Calibration:No need
Interface Type
IN/OUT:XT90(Cable end)/Amass 8.0(Module end)
Power:5025850670
CAN:GHR-04V-S
Appearance
Size:46.5mm×38.5mm×22.5mm
Weight:76g

CUAV CAN PMU Power Module High Precision Power Detection Unit Module For UAV
CUAV CAN PMU Power Module High Precision Power Detection Unit Module For UAV
CUAV CAN PMU Power Module High Precision Power Detection Unit Module For UAV
CUAV CAN PMU Power Module High Precision Power Detection Unit Module For UAV
CUAV CAN PMU Power Module High Precision Power Detection Unit Module For UAV
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Friday 30 April, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here