CUAV PW-LINK Wifi Telemetry Module Wifi Data


$25.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
The pw-link model is the data transmission module, 2.4G wireless data
transmission module has the following advantages.:
• Network processor - high performance,ESP8266;
• Radio communication, simple and fast and low cost UDP;
• all kinds of mobile devices can be connected quickly through WiFi module;
• It should be used in all kinds of ground station software supporting UDP communication;
Product Details
Version:Pixhack / Pixhawk (Optional)
Wireless standards:IEEE 802.11g、IEEE 802.11b
Transmission speed:11g: The highest54Mbps、11b:The highest 11Mbps
Attended mode:UDP:14550
Channel range:1 – 13
Frequency range:2412 – 2472MHz
Transmitting power:18dbm
Antenna type:UFL type
Wireless safe:WPA/WPA2 security mechanism
Communication protocols:Transparent transmission mode of serial port
Traffic rate:57600
Working voltage:5V +- 0.25V
Working current:100MA
Working temperature:-20 – 50°C
Operation humidity:10% – 90%RH( noncondensing )
Storage Temperature:-40 – 80°C
Storage Humidity:5% – 90%RH( noncondensing )
Size:28*17*1.2mm
Weight:65g

CUAV PW-LINK Wifi Telemetry Module Wifi Data Transmission For PIX FPV Telemetry PIXHACK PIXHAWK Flight Controller
CUAV PW-LINK Wifi Telemetry Module Wifi Data Transmission For PIX FPV Telemetry PIXHACK PIXHAWK Flight Controller
CUAV PW-LINK Wifi Telemetry Module Wifi Data Transmission For PIX FPV Telemetry PIXHACK PIXHAWK Flight Controller
CUAV PW-LINK Wifi Telemetry Module Wifi Data Transmission For PIX FPV Telemetry PIXHACK PIXHAWK Flight Controller
CUAV PW-LINK Wifi Telemetry Module Wifi Data Transmission For PIX FPV Telemetry PIXHACK PIXHAWK Flight Controller
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Thursday 06 May, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here