CUAV X7+ Flight Controller NEO V2 GPS Pixhawk


$549.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
X7+ autopilot uses STM32H743 series processors CPU, Cortex-M7 core
(with double precision Floating-Point Unit). It makes operating frequency
increase to 480Mhz, 2MB Flash,1MB RAM,Meet the higher computing needs of
flight controllers Compared with the STM32F7 product line, the dynamic
power consumption efficiency is doubled.
Product Details
X7+ Flight Controller
Processor:STM32H743
Frequency:480MHz
Flash:2MB
RAM:1MB
Acce & Gyro:ICM-42688-P;ICM-20689;ICM-20689
Compass:RM3100
Barometer:Ms5611x2
UART:5
I2C:6 ( 2 interface are integrated in GPS & SAFETY & UART4 )
CAN:2
ADC IN:1 ( Support 6.6V / 3.3V )
SPI:1
PWM OUT:14 ( M1~M12 Support DSHOT protocol)
RC IN:1 ( Support PPM SBUS DSM)
RSSI:PWM or 3.3V analog voltage
Power IN:Power A for ADC protocol , Power C for CAN protocol
GPS Port:1 ( Other ports can be configured as GPS 2 , default is UART4)Safety
switch:Integrated into GPS & SAFTETY port
Beeper:Integrated into GPS & SAFTETY port
Debug:1 ( UART7 )
JATG:1
USB:Type-C x 1
TF slot:1
Rated voltage:4.5 ~ 5.5V
USB voltage:4.75 ~ 5.25V
Servo voltage:0 ~ 36V
Working Temp:-20 ~ 85°C
LxWxH:77x45.5x39mm
Weight:104g
Ardupilot Firmware:Ardupilot 4.10 or above version Copter /
Plane / Helicopter / VTOL / unmanned vehicle / Rover , etc PX4 Firmware:PX4 1.12.3 or above version Copter / Plane /
Helicopter / VTOL / unmanned vehicle / Rover , etc
NEO V2 GPS
Chip Type
- GPS Location:UBLOX M8N
- RGB Status light:NCP5623C
- Compass:IST8310
- Buzzer:Passive buzzer
- Buzzer:Physical buttons
Positioning Performance
- Accuracy:3D Fix
- Update rate:10Hz(Max)
- Acquisition:Cold Start 26S | Host Start 1.5S | Aided Start 2S |
Reacquisition 1S
- Receiver type:72 Channels GPS/QZSS L1 C/A, GLONASS L10F BeiDou
B1I, Galileo E1B/C SBAS L1 C/A: WAAS, EGNOS, MSAS, GAGAN
- Sensitivity:Tracking & Navigation -167dBm | Cold Start -148dBm |
Hot Start -156dBm | Reacquisition -160dBm
- Functional
1. Advanced jamming
2. Fast search satellite speed Security and integrity protection
3. Receiving up to three GNSS at the same time
Working Conditions
- Input voltage:5V
- Temperature:-10 - 70°C
CUAV-X7+
CUAV X7+ Flight Controller NEO V2 GPS Pixhawk Open Source PX4 ArduPilot GNSS FPV RC Drone Quadcopter
CUAV X7+ Flight Controller NEO V2 GPS Pixhawk Open Source PX4 ArduPilot GNSS FPV RC Drone Quadcopter
CUAV X7+ Flight Controller NEO V2 GPS Pixhawk Open Source PX4 ArduPilot GNSS FPV RC Drone Quadcopter
CUAV X7+ Flight Controller NEO V2 GPS Pixhawk Open Source PX4 ArduPilot GNSS FPV RC Drone Quadcopter
CUAV X7+ Flight Controller NEO V2 GPS Pixhawk Open Source PX4 ArduPilot GNSS FPV RC Drone Quadcopter
CUAV X7+ Flight Controller NEO V2 GPS Pixhawk Open Source PX4 ArduPilot GNSS FPV RC Drone Quadcopter
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Tuesday 09 August, 2022.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here