F722 40A AIO Dual USB Flight Control 4IN1 BLHELI_ S ESC 2-6S


$92.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
1. The PCB adopts high-end 8-layer 2oZ thick copper skin,
which has stronger over-current capability and good heat dissipation.
2. MOS adopts imported 40V high current resistance MOS, long life and strong load capacity.
3. Using industrial grade LDO, high temperature resistance.
4. Using high-quality Japanese Murata capacitors, strong filtering performance
Product Details
Size: 32* 32mm (25.5mm-26.5mm mounting hole)
Packing size: ΓΈ63*32mm
Product net weight: 7g
Package weight: 25g
Flight control parameters:
CPU: STM32F722RET6
IMU: MPU6000
OSD: AT7456E
Barometer: integrated
BEC: 5V/3A
Uart: 5
LED: Support WS2812 and other programmable
Sensor: Built-in current sensor
Flight control firmware version: HAKRC F722D
Receiver: CRSF / Frsky/ Fut aba/ Flysky/TBS Crossfire/ DS MX: DS M2 receiver
ESC parameters:
Firmware support: BLHELI_ S
Protocol support: PWM, Oneshot125, Oneshot42,
Multishot, Dshot150, Dshot300, Dshot600
Input voltage: 2S-6S Lipo
Continuous current: 40A
Peak current: 50A
Current meter proportional value: 450
Firmware version: BLHELI _S (G- H-30)
HAK-F722-40A
HAKRC F722 40A AIO Dual USB Flight Control 4IN1 BLHELI_ S ESC 2-6S 25.5x25.5mm For DJI HD VTX CADDX CRSF FPV Racing Drone
HAKRC F722 40A AIO Dual USB Flight Control 4IN1 BLHELI_ S ESC 2-6S 25.5x25.5mm For DJI HD VTX CADDX CRSF FPV Racing Drone
HAKRC F722 40A AIO Dual USB Flight Control 4IN1 BLHELI_ S ESC 2-6S 25.5x25.5mm For DJI HD VTX CADDX CRSF FPV Racing Drone
HAKRC F722 40A AIO Dual USB Flight Control 4IN1 BLHELI_ S ESC 2-6S 25.5x25.5mm For DJI HD VTX CADDX CRSF FPV Racing Drone
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Monday 25 April, 2022.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here