FrSky RXSR-FC OMNIBUS F4 Fireworks V2 FPV Drone F C


$95.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features The FrSky RXSR-FC (OMNIBUS F4 Fireworks) uses the ICM20608 over SPI to produce stable flight performance. Integrated with the RXSR receiver mounted on-board protection box, and the ICM20608 runs perfectly under 32k Gyro loop. Also onboard are a barometer and AB7456 OSD chip for the Betaflight integrated OSD. The RXSR-FC (OMNIBUS F4 Fireworks) supports 3-6s Lipo direct input, built-in hall Current Sensor and Power Filter as well. The on Board PDB is tweaked by using 12-Layer PCB design. There is only 0.2-0.5 mohm internal resistance from input to each output pad. Tantalum Capacitors can be added to the board (not included) Solder pads added for VTXand Camera Control (next to Video pads) The orientation of IMU FPC optimized Gyro ribbon cable redesigned to fit without extending outside the board Added an 8v BEC and LC Filter for the camera and VTX power This board now has 5 UART ports Product Details STM32 F405 MCU, Runs Betaflight firmware (supported from v3.2) FrSky RXSR receiver in protection box ICM20608 over SPI Bus in dampening box (optional MPU6000) 30.5×30.5 mm mounting holes Supports Lipo direct plug-in (3-6S) Built-in sensor damper Supports 5V 1A BEC output (Buck) Supports 8V 1A BEC with LC filter output for the camera and VTX (Buck) STM32 controls OSD chip over SPI in DMA mode (Betaflight OSD) Built-in hall Current Sensor Built-in Professional Level PDB More caps to reduce power noise. FrSky RXSR-FC (OMNIBUS F4 Fireworks) uses the ICM20608
FrSky RXSR-FC (OMNIBUS F4 Fireworks) uses the ICM20608
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Monday 07 January, 2019.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here