FrSky RXSR-FC OMNINXT F7 FPV Drone Flight Controller


$125.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
The FrSky RXSR-FC (OMNINXT F7) is developed based on the newly designed NXT architecture. It is integrated with the RXSR receiver mounted in a protection box, and uses the trusty MPU6000 Gyro with an additional ICM20608 on top. With the onboard dampening box, the gyros run perfectly on 32k loop time. The NXT also comes with 2 different BECs and 6 UARTs. The RXSR-FC (OMNINXT F7) supports 3-6s Lipo direct input, built-in BEC for camera / VTX and Power Filter. This FC is designed to be able to pair with 4in1 ESCs to form a powerful combo, and also has pins for individual ESCs. Product Details RXSR Receiver STM32 F7 MCU Processor Gyro #1: MPU6000 8kHz Gyro #2: ICM20608 32kHz Integrated PDB & OSD (SPI/DMA) 6UART Ports
Direct plug-in 3-6S Lipo
5V 1000mA BEC
8V 1000mA BEC with LC filter
3V max. 200mA
F7 MCU processors
FrSky RXSR receiver in protection box
Two gyros onboard: MPU6000 for sampling up to 8khz and ICM20608 for sampling up to 32khz 30.5×30.5mm Mounting holes
Supports 3-6S Lipo
More caps to reduce power noise
Built-in sensor damper
Built-in 5V 1A BEC output (Buck)
Built-in 8V 1A BEC with LC filter output for the camera and VTX (Buck)
STM32 controls OSD chip over SPI in DMA mode (Betaflight OSD)
Port for easy connection to 4-in-1 esc (SH1.0 8P)
Solder pads added for VTXand Camera Control (next to Video pads)
FrSky RXSR-FC OMNINXT F7 FPV Drone Flight Controller
FrSky RXSR-FC OMNINXT F7 FPV Drone Flight Controller
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Monday 07 January, 2019.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here