GPS pre-configured for use with APM 2.5/2.5.2/2.6/Pixhawk


$57.50

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
GPS pre-configured for use with APM 2.5/2.5.2/2.6/Pixhawk and include cable for APM
Features
•u-blox LEA-6H GPS module
•5Hz update rate
•32k I2C EEPROM for save configuration
•Build in 25 x 25 x 4mm ceramic patch antenna
•LNA and SAW chip
•3.3V LDO low noise regulator
•UART (TTL) port with EMI protection
•3V lithium Rechargeable battery
•Power and fix indicator LEDs
•Reverse polarity protection for input power
Product Details
Default parameter
•UBX protocol
•Baud rate : 38400
•Nav rate : 4Hz
•TIMEPULSE (fix LED) rate : 1Hz
â—†Other
•Dimension: 40 x 40 x 9mm
•Weight: 17g/20g (include cable)
•Hole diameter: 3.1mm


  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Saturday 16 August, 2014.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here