HEX Airbot Mini Carrier Board kit for Pixhawk Cube


$130.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
The Mini carrier Board is one of the best ways to integrate a pixhawk
2.1 cube into a drone. It provides maximum connectivity in a small size.
Now accompanied by a Mini PDB, this combo is ideal for installing a cube
in any drone, and simplifies the installation of the autopilot, even in
small drones. Actual version V1.4
(Pixhawk 2.1 Cube et GPS Here not included)
Product Details
The mini carrier Board Airbot has been specially designed to allow
the installation of a Pixhawk 2.1 cube on any drone. It offers
complete connectivity in a reduced format:
-2 power ports
-RC input (PPM/S. BUS + 5V)
-Spectrum input + 3.3 v
-Serial ports: 1/2/3/4/5
– I2C + CAN
– GPS1 + GPS2
-PWM signal distribution for motors (up to 8)
-ect… (see user manual)
TECHNICAL SPECIFICATIONS:
Mini carrier Board:
Dimensions : 50.5*57.5mm (1.98*2.26 inch)
Height with cube: 24.65 mm (EXCL. PSM + 2.75 mm approx)
Weight: 19gr (0.041 lb) (incl. connectors and PSM)
Mini Power Distribution Board :
Dimensions : 60.5*69mm (2.36*2.71 inch)
Weight: 21g (0.046 lb)
HX4-06009
HEX Airbot Mini Carrier Board Set For RC Drone Pixhawk Open Source Flight Control
HEX Airbot Mini Carrier Board Set For RC Drone Pixhawk Open Source Flight Control
HEX Airbot Mini Carrier Board Set For RC Drone Pixhawk Open Source Flight Control
HEX Airbot Mini Carrier Board Set For RC Drone Pixhawk Open Source Flight Control
HEX Airbot Mini Carrier Board Set For RC Drone Pixhawk Open Source Flight Control
HEX Airbot Mini Carrier Board Set For RC Drone Pixhawk Open Source Flight Control
HEX Airbot Mini Carrier Board Set For RC Drone Pixhawk Open Source Flight Control
HEX Airbot Mini Carrier Board Set For RC Drone Pixhawk Open Source Flight Control
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Friday 19 November, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here