HEX Pixhawk2 Cube Black+ Main Control Module/For Flight Control


$300.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
Cube black + upgrades the IMU sensors to ICM20948 andICM20602 , these two sensors
have better performance better Data measurement and lower power consumption , can play
a better performance in the IMUReal-time triple redundant IMU system on flight
controller provide backups when error occurred , which provide safety and stability
Product Details
Processor:STM32F427
Frequency:180MHZ
I / O PWM Voltage:3.3V
RAM:256K
Flash:2M
Weight:32.8g
Power:5.3V
Redundancy:Triple Redundancy
Accelerometer:ICM20948/MPU 9250/ICM20602
Gyroscope:ICM20948/MPU 9250/ICM20602
Magnetometer:ICM20948/MPU 9250
Barometer:MS5611 * 2
Isolation System:Y
Temp Regulation:Y

HEX Pixhawk2 Cube Black+ Main Control Module/For Flight Control PX4 PIX
HEX Pixhawk2 Cube Black+ Main Control Module/For Flight Control PX4 PIX
HEX Pixhawk2 Cube Black+ Main Control Module/For Flight Control PX4 PIX
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Saturday 08 May, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here