HolyBro pixhawk radio 100mW 433Mhz Telemetry Radio - V3


$45.00

 Sold Out 

  • Description
  • Details
  • Reviews
  • Custom Tab
Processing:
100 mW maximum output power (adjustable) -117 dBm receive sensitivity
Open-source SIK firmware
RP-SMA connector
2-way full-duplex communication through adaptive TDM UART interface
Transparent serial link
MAVLink protocol framing
Frequency Hopping Spread Spectrum (FHSS) Configurable duty cycle
Error correction corrects up to 25% of bit errors Open-source SIK firmware
Configurable through Mission Planner & APM Planner
FT230X is a USB to BASIC UART IC
Features
Interchangeable air and ground modules 915 or 433 mHz
Micro-USB port
4-position JST-GH connector
Status LEDs
The radios have 2 status LEDs, one red and one green. The meaning of the different LED states is:
Green LED blinking - searching for another radio
Green LED solid - link is established with another radio
Red LED flashing - transmitting data
Red LED solid - in firmware update mode
Connecting to Pixhawk4
Use the 4 pin JST-GH connector that should have come with the radio to connect the radio to your Pixhawk4’s “Telem 1” (“Telem 2” can also be used but the default recommendation is “Telem1”).
Connecting to a PC
Connecting the radio to your Windows PC is as simple as connecting the micro USB cable (which should have been included with the radio) to your PC. The necessary drivers should be installed automatically and the radio will appear as a new “USB Serial Port” in the Windows Device Manager under Ports (COM & LPT). The Mission Planner’s COM Port
selection drop-down should also contain the same new COM port.
Product Details
Dimensions: 26 x 53 x 10.7mm (without antenna)
Power Supply voltage: 5VDC (from USB or JST-GH)
Transmit current: 100 mA at 20dBm
Receive current: 25 mA
Serial interface: 3.3 V UART
Item Packing
2 x data radios
2 x antennas
2 x conversion connectors
2 x 6-pin to 4-pin cables
1 x Micro USB cable
1 x OTG cable
HolyBro 100mW 433Mhz Telemetry Radio - V3
  • 0 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Friday 14 September, 2018.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here