Holybro PM02 V3 Power Module for APM Pix32 Pixhawk4 FC


$28.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
PM02 is a simple way of providing your APM and Pix32 with clean power from a LiPo battery as
well as current consumption and battery voltage measurements, all through a 6-pos cable.
The on-board switching regulator outputs 5.2V and a maximum of 3A from up to a 12S LiPo battery.
The Power Module comes completely assembled with XT60 connectors, and wrapped in shrink tubing for protection.
The Power Module is designed to power APM,Pix32, a RC receiver and APM accessories. (GPS, radio).
It is not designed to power servos. Use your aircraft's own ESC/BEC for that.
The GH terminal is also compatible with both Pix32,Pixhawk4,Pixhawk4 mini and Durandal.
Product Details
Model: PM02 V3
Tool Supplies: Assembly Category
Technical parameters: Value 2
For Vehicle Type: Helicopters
Four-wheel Drive Attributes: Assemblage
Wheelbase: Bottom Plate
Max input voltage: 60V
Max current sensing: 120A
Voltage and current measurement configured for 5V ADC
Weight: 20g
colour:Black+red
Material:plastic
size:3.3 x 2.6 x 0.6cm

Holybro PM02 V3 Power Module for APM Pix32 Pixhawk4 Flight Controller
Holybro PM02 V3 Power Module for APM Pix32 Pixhawk4 Flight Controller
Holybro PM02 V3 Power Module for APM Pix32 Pixhawk4 Flight Controller
Holybro PM02 V3 Power Module for APM Pix32 Pixhawk4 Flight Controller
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Wednesday 10 March, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here