Lidar Range Finder Sensor Module TFmini Plu Module IP65


$59.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
TFmini Plus is a milestone of Benewake in the process of promoting the cost-effective -LiDAR. Apart from low-cost, small-size and low-power-consumption, TFmini Plus also improves the frame rate, introduces IP65 enclosures and optimizes various compensation algorithms. These new characters greatly expand the application fields and scenarios of TFmini Plus. The product is compatible with both the UART and IIC interface. Different interfaces can be switched by commands. Product Details
Range: 0.1-12m
Accuracy: ±5cm@(0.1-6m),±1%@(6m-12m)
Resolution: 5mm
Frequency: 1-1000Hz, standard is 100Hz
Light Sensitivity: 70klux
Operation temperature: -20℃~60℃
Waterproof: IP65
Light and Wave length: LED 850nm
Receiving Anger: 3.6 degree
Supply Voltage: 5V±0.5V
Average current: 110mA
Average Power: 550mW
Peak Current: 300mA
Communication Level: LVTTL(3.3V)
Interface: UART
Cable length: 30cm
Item Packing
TFmini Plus LiDAR x 1
Lidar Range Finder Sensor Module TFmini Plu Module IP65 Waterproof Dustproof Short-range Distance Sensor
Lidar Range Finder Sensor Module TFmini Plu Module IP65 Waterproof Dustproof Short-range Distance Sensor
Lidar Range Finder Sensor Module TFmini Plu Module IP65 Waterproof Dustproof Short-range Distance Sensor
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Friday 10 May, 2019.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here