MATEKSYS Matek OPTICAL FLOW & LIDAR SENSOR 3901-L0X for RC FPV


$35.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
MATEKSYS Matek OPTICAL FLOW & LIDAR SENSOR 3901-L0X for RC FPV Racing Drone
Product Details
Optical Flow: PMW3901
Lidar: VL53L0X
Interface UART
Protocol: INAV MSP
Working Range: 8cm~200cm
Field of view: 42 degree(PMW3901), 27 degree(VL53L0X)
Minimum Illumination >60Lux
Input voltage: 4.5~5.5V
Power Consumption: 40mA
Size: 36*12mm, 2g
Tips
Make sure Optical Flow lens to ground >2cm for opflow initialization while FC starting up.
Maximum range of VL53L0X is 2m, Altitude hold 0~2m @ throttle 0~100% if VL53L0X is enabled.
Any unused UART of FC supports it
Sonar connection (Trig & Echo) has not been implemented
MATEKSYS Matek OPTICAL FLOW & LIDAR SENSOR 3901-L0X for RC FPV
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Thursday 19 December, 2019.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here