Mauch Power Module For Pixhawk2 PIX Flight Control 100A/14S


$45.90

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
Mauch Power Module For Pixhawk2 PIX Flight Control 100A/14S RC Drone Parts
Product Details
MAUCH 074 : HS-100-HV / PIXHAWK
50A-current measurement sensor board , based on Allegro Hall Sensor ACS-100U
The voltage reading of the Lipo is optimised for up to l4s Lipo packs.
This Sensor board needs a power supply . So please select the matching BEC according your preference from the BEC section.
The BEC will also power the flight controller as well as the attached equipmentlike GPS , telemetry... etc.
Connected to the sensor are 2x10cm AWG12 wire ( red ) as a standard.

Mauch Power Module For Pixhawk2 PIX Flight Control 100A/14S RC Drone Parts
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Thursday 06 May, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here