Mauch Power Module For Pixhawk2 PIX Flight Control 200A/6S


$40.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
Mauch Power Module For Pixhawk2 PIX Flight Control 200A/6S RC Drone Parts
Product Details
MAUCH 075 : HS-200-LV
200A-current measurement sensor board , based on Allegro Hall Sensor ACS-200U.
The voltage reading of the Lipo is optimised for up to 6S Lipo packs.
This Sensor board needs a power supply . So please select the
matching BEC according your preference from the BEC section.
The BEC will also power the flight controller as well as
the attached equipment like GPS ,telemetry...etc.
Connected to the sensor are 2x10cm AWG10 wire ( red ) as a standard.

Mauch Power Module For Pixhawk2 PIX Flight Control 200A/6S RC Drone Parts
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Thursday 06 May, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here