Mauch Sensor Hub X2 3D Enclosure Power Module


$12.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
HEX Mauch Sensor Hub X2 3D Enclosure Power Module For Pixhawk2
PIX Flight Control RC Drone Parts
Product Details
MAUCH 081: Enclosure for Sensor Hub X2
3D printed enclosure for the Sensor Hub X2
The enclosure should be installed with double side tape ( included ).
The Sensor Hub X2 will just "click" into the bottom part and the
top should be secured with any ABS (Acetone) glue or Cyanoacrylate (super) glue.
REM : It is the nature of 3D printed parts, that the surface
is not as smooth as in-jection molded parts.
MAUCH081
Mauch Sensor Hub X2 3D Enclosure Power Module For Pixhawk2 PIX Flight Control RC Drone Parts
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Monday 24 January, 2022.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here