Multicopter Flight Controller KK V2.5 - (X mode firmware)


$27.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
THE FIRMWARE OF THIS VERSION IS FOR "X" TYPE QUADCOPTERS.(You can flash to other modes firmwares when needed)
-Support multicopter configurations from 2 to 6 rotors.
-firmware upgrader available as optional part, you can update the firmware to the version you prefer.
-Three adjustable potentiometers increase or decrease gyro gain for all three axis (Roll, Pitch and Yaw) and can be used to calibrate the ESCs and reverse the gyro directions if necessary during pre-flight setup.
Product Details
-Dimension: 50mm × 50mm X 1
-Weight:13g X 1
  • 99 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Saturday 29 December, 2012.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here