NAZE32 32-bit 10DOF 3-Axis Flight Controller Module


Add to Cart:

  • Description
  • Details
  • Reviews
  • Custom Tab
NAZE 32 10DOF 3-Axis Flight Controller Module with HMC5883L MS5611 for RC Airpla
Product Details
- 36x36 mm
- 3-axis MEMS gyro + accelerometer (MPU6050)
- 3-axis magnetometer (HMC5883L)*
- Pressure sensor (MS5611)*
- Flexible motor outputs, support various airframe types
- Quad/Hexa/Tri/Bi/Y4/Y6/Octo/Camera Gimbal.(Default is Quad-X)
- Up to 8 ch RC input-supports standard receivers(PWM), PPM Sum
receiver(FrSky, etc), or Spektrum Satellite receiver.
- Battery voltage monitoring
- Modern 32-bit processor running at 3.3V/72MHz(STM32F103CB).
- Onboard MicroUSB for setup and conguration
- MultiWii-based configuration software for easy setup
- rev4 hardware

  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

This product was added to our catalog on Wednesday 12 November, 2014.



Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.

your alt text here