Openpilot MINI CC3D Atom NANO CC3D Side Pin Flight Controller


$29.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
Openpilot MINI CC3D Atom NANO CC3D Side Pin Flight Controller for FPV QAV 250 400 Quadcopter
This CC3D Atom is about half the size of the regular OpenPilot CC3D, but with the same functionality.
Now you can get all the great features and functionality of the full sized CC3D flight controller board but at about 1/2 the size! Product Details
- The CC3D provides a crisp feel when flying tricopters, quads, hexas, octocopters, and even fixed wing planes.
- Powerful STM32 32-bit micro-controller running at 90MIPs with 128KB Flash and 20KB RAM.
- 3-axis high-performance MEMs gyros and 3-axis high-performance MEMs accelerometer.
- 4 layer PCB for superior electrical noise reduction and flight performance.
- Software support for Windows, Mac and Linux.
- Direct high speed USB support with no drivers required.
- Spektrum satellite receiver support.
- Futaba S-BUS hardware support.
- Innovative Flexi-port technology for superior port flexibility.
- 4Mbits on-board EEPROM for configuration storage.
- This OpenPilot CC3D Atom board also includes a high quality, protective case.
- Side pin CC3D Atom flight controller
Specifications:
- Item name: CC3D Atom/Mini CC3D/CC3D EVO
- Size (board only): 30mm x 17mm
- Size (in case): 22 x 38 x 12mm WxLxH
Item Packing
- Side pin CC3D Atom Flight controller x 1
- 8P cable x 1
- 4P expansion cable x 1
- Two sided adhesive tape x 1
- V-type receiver antenna sleeve
- Mini CC3D anti-vibration board
MINI CC3D Atom NANO CC3D
MINI CC3D Atom NANO CC3D
MINI CC3D Atom NANO CC3D
MINI CC3D Atom NANO CC3D
MINI CC3D Atom NANO CC3D
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Saturday 28 March, 2015.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here