Pix Hawk Pixracer R15 Autopilot xracer PX4 Mini full kit


$230.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
NEW Pixracer R15 Autopilot xracer PX4 Mini Edition Flight Control Kit
Product Details
Microprocessor:
32-bit STM32F427 Cortex M4 core with FPU rev. 3
168 MHz/256 KB RAM/2 MB Flash
Sensors:
Invensense MPU-9250 3-axis accelerometer/gyroscope/magnetometer
MEAS MS5611 barometer
ST LIS3MDL magnetometer
Interfaces:
5x UART (serial ports), one high-power capable, 2x with HW flow control and GPS+I2C® CAN
Spektrum DSM / DSM2 / DSM-X® Satellite compatible input up to DX9 and above.
Futaba S.BUS® & S.BUS2® compatible input
FRSky Telemetry port output
Graupner SUMD
Yuneec ST24
PPM sum input signal
OneShot PWM output (Configurable)
RSSI (PWM or voltage) input
I2C
SPI
External microUSB port
JTAG
Dronecode Debug connector
WiFi Telemetry & firmware update via ESP8266 (Included!)
6x PWM outputs
Pixracer R15 Autopilot xracer PX4 Mini Edition Flight Control Kit
Pixracer R15 Autopilot xracer PX4 Mini Edition Flight Control Kit
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Thursday 17 October, 2019.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here