Pixhack V5 nano Small Flight Controller For Ardupilot PX4 Drone


$199.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
V5 nano is an autopilot for space-constraint applications designed by CUAV in collaboration with the PX4 team. It is based on the Pixhawk FMUv5 design standard and is optimized to run PX4 firmware, and is also compatible with ArduPilot firmware.
Product Details
Package without NEO GPS
- 1 x V5 nano Flight Controller
- 2 x Dupont Cables
- 1 x ADC6.6 Cable
- 2 x I2C/CAN Cables
- 1 x SBUS Signal Cable
- 1 x RSSI Cable
- 1 x DSM Signal Cable
- 1 x ADC3.3 Cable
- 1 x Debug Cable
- 1 x Safety Switch + Cable
- 1 x Voltage Current Cable
- 1 x PW-Link Module + Cable
- 1 x Power Suppl Module
- 1 x 16GB Memory Card
- 1 x I2C Expansion Board
- 1 x TTL Board
Pixhack V5 nano Small Flight Controller For Ardupilot PX4 Drone
Pixhack V5 nano Small Flight Controller For Ardupilot PX4 Drone
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Monday 05 August, 2019.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here