Pixhawk2.1 Standard kit



$238.00

 Sold Out 

  • Description
  • Details
  • Reviews
  • Custom Tab
Get Started on your road to Autonomy! This Kit contains the following items
The Cube.... the brains behind the opperation.
A standard carrier board.(no compatible with Intel Edison Chip)
1 Power Brick (two power bricks can be fiter for redundant power.)
Cable set that allows you to connect to your old Telemetry module, GPS, and sensors
Detailed includes(Cables for accessories are JST to DF13 cables which are compatible with old
pixhawk accessories, such as Telemetry, Power Brick or GPS): PIXHAWK2.1 Cube * 1 PIXHAWK2.1
Carrier * 1 POWER Brick Mini * 1 SD Card(inserted in Cube) * 1 TELEM Cable * 2 POWER Cable * 1 I2C Cable * 1 BUZZER Cable * 1 MICRO USB Cable * 1 GPS1 Cable(with saftey switch) * 1 GPS2 Cable * 1 I2C Splitter * 1 Mounting Screws(M2.5*8) * 4 3M Double Sided Foam Tapes
To take full advantage of the Pixhawk 2.1, Please add the new GPS with built in Safety switch.
  • 0 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Friday 23 February, 2018.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here