RacerCube Integrated F3 EVO 4 In 1 20A F396 ESC Frsky 8CH PPM/SB


Add to Cart:

  • Description
  • Details
  • Reviews
  • Custom Tab
1. Buzzer ready
3. Ultra-light integration suite,PNP, do not need cumbersome wiring
4. F3_EVO FLIGHT CONTROLLER Jaw-Dropping Flight Performance
5. STM32F3 chip F3 EVO flight control, support CLEANFLIGHT / BETAFLIGHT program
6. Built-in MWOSD, aircraft real-time data status real-time back to the FPV display or GOGGLES
7. Built-in SD card, integrated CLEANFLIGHT BLACKBOX function, PID adjustment more at a glance
8. Integrated FRSKY compatible 8-channel SBUS / PPM two-way receiver, FRSKY Taranis X9D and DJT / DFT / XJT tuner directly on the frequency can be used
9. 4IN1 ESC Little BEE 20A F396 Chip ESC Ready, BLHELI Pass-through Ready. Based on high-quality F396 MCU ESC, support Oneshot125 / Multishot, support Damped Light function, can be directly configured by CLEANFLIGH
Weight: 23 g
Size: 36mm * 36mm * 25mm
Installation hole distance: 30.5mm * 30.5mm
Product Details
F3 EVO Flight Control Integrated MWOSD and PCB board
Firmware: Cleanflight 1.13.0
STM32F303 CPU, 72Mhz inc FPU
MPU9250 accelerometer/gyro/compass (connected via SPI)
BMP280 barometer
Compatible PPM/CPPM/SBUS/DSM2/DSMX Receiver
Integrate PDB support 2s-6s Input
Frsky Receiver Integrated F3 Flight Control BLACKBOX Functionality and External Expansion Interface
Channel: 8
Working voltage: 4-6.5V
Frequency range: 2400-2483.5Mhz
Output signal: SBUS/PPM
Dual way transmission: Yes(D8 mode)
Transmit distance: > 1Km
Feedback signal: RSSI, 3S voltage (A1)
With Failsafe @Throttle 3ch
Compatible with X9D(D8 mode)/XJT (D8 mode)/DJI/DFT/DHT
Racercube LittleBee ESC 4IN1 20A*4
F396 MCU, 48Mhz Runs BLHELI LittieBee Pro 20A firmware
Support 3-6S Li-po
4PWM input,
Supports oneshot PWM
Only 35x35mm, mount holes 30x30mm (on new batch, the holes will bechanged to 30.5x30.5mm)
Supports damped light
no BEC output
F3 EVO Flight Control Integrated MWOSD
F3 EVO Flight Control Integrated MWOSD
F3 EVO Flight Control Integrated MWOSD
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

This product was added to our catalog on Saturday 17 December, 2016.



Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.

your alt text here