Radiolink Mini GPS System Module M8N SE100


$30.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
Top Configuration
-GPS decoder chip: Radiolink M8N GPS, with u-blox UBX-M8030(M8), 72-channel, MMIC BGA715L7 from Infineon
and 13 years of RF experiences, is much better than single GNSS 7N.
A.Concurrent reception of GPS/QZSS L1 C/A,GLONASS L10F, BeiDou B1
B.SBASL1 C/A:WAAS, EGNOS, MSAS
- Antenna : 2.5dbI high gain and selectivity ceramic antenna
- Power amplify IC: MMIC BGA715L7 from Infineon
- Filter: SAWF(Surface acoustic wave filter) form Murata
- Geomagnetic: HMC5983
Professional Design
Radiolink M8N GPS, benefits from professional wireless experiences of Radiolink engineers, exceed the limitation
of IC sensitivity index from circuit schematic design to PCB placement.
1 meter position accuracy, positioning in 23 seconds and valley stationkeeping ability make Radiolink GPS much
better than the similar products.
High Performance Cost Ratio
Reasonable price with better hardware, software configuration and brand new exterior designs.
Product Details
Brand name: Radiolink
Item name: M8N GPS Module
Positional Accuracy: 1m precision when working with concurrent GNSS, 2.5m precision when working with single
GNSS.
Velocity precision: 0.1m/s
Max height: 50000m
Max speed: 515m/s
Max acceleration: 4G
Max update rate: up to 18Hz
Sensitivity
Tracking & Nav.: -167dBm; Reacquisition:-163dBm; Cold start:-151dBm; Hot start:-159dBm
Time to first fix: Cold start: 26s, Hot start:1s.
Power supply: voltage 3.3VDC+-5%, current 50~55mA Ports:
A. GPS UART interface, baud rate: 1.2K/4.8K/9.6K/19.2K/38.4K/57.6K/112.5K
B.Geomagnetic I2C interface
PIXSE100GPS
Radiolink Mini GPS System Module M8N SE100 for Pixhawk Flight Controller UBX-M8030 M8
Radiolink Mini GPS System Module M8N SE100 for Pixhawk Flight Controller UBX-M8030 M8
Radiolink Mini GPS System Module M8N SE100 for Pixhawk Flight Controller UBX-M8030 M8
Radiolink Mini GPS System Module M8N SE100 for Pixhawk Flight Controller UBX-M8030 M8
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Friday 06 August, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here