SN-L+ SNL+ HD OSD MAVLINK Flight Controller BN220 GPS Combo Set


$79.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
- 7-channel PWM output, SBUS/PPM input
- Pixel-level OSD, support SN-AAT
- Support DJI FPV Air Unit
- Support MAVLINK, adapt to open source data transmission
and high-definition image transmission
- Tower PMU module, stable and safe, and friendly to install
- Multiple flight modes available
- Support channel multiplexing, throttle differential
- Computer-free parameter adjustment
- Imported capacitors and chips are used to ensure stable
power supply for the flight controller and clear images.
- The upper bottom plate can be quickly disassembled to
facilitate the replacement of the flight control between different aircraft.
- Using damping pads to softly connect the flight controller and the aircraft.
Product Details
Item Name: SN-L+ Flight Controller
Dimension: 38*24*10mm
PMU Output Voltage: 12V/5V
PMU Output Current: 2A(Continuous),3A(Max)
Max. Test Current: 75A
Max. Input Voltage: 26V
1x SN-L+ Flight Controller
1x BN220 GPS
1x Upgrade Module
3x GH1.25 Cable
1x PMU Cable
SN-L+ SNL+ HD OSD MAVLINK Flight Controller BN220 GPS Combo Set for DJI FPV Air Unit RC Airplane Fixed-Wing Drones DIY Parts
SN-L+ SNL+ HD OSD MAVLINK Flight Controller BN220 GPS Combo Set for DJI FPV Air Unit RC Airplane Fixed-Wing Drones DIY Parts
SN-L+ SNL+ HD OSD MAVLINK Flight Controller BN220 GPS Combo Set for DJI FPV Air Unit RC Airplane Fixed-Wing Drones DIY Parts
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Thursday 07 April, 2022.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here