UAV NEO V2 Pro GPS Bus High Precision Positioning Module GNSS


$175.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
UAV NEO V2 Pro GPS Bus Drone Open Source Flight Control High Precision Positioning
Module GNSS For UAV Drone Racing
NEO V2 Pro is a GNSS positioning system based on the UAVCAN communication protocol.
It integrates an industrial-grade compass, barometer, flight controller status
lights, buzzer, and safety switch in one; it has high safety and strong anti-interference characteristics.
Product Details
Processor:STM32F417M
Compass:RM3100
Barometer:MS5611
GNSS receiver:UBLOX Eighth Generation Navigation and Positioning Receiver (M8N)
GNSS concurrently:GPS/QZSS L1 C/A,GLONASS L10F ,BeiDou B1I,Galileo E1B/C,SBAS L1 C/A:
WAAS, EGNOS, MSAS, GAGAN
Nav. update rate:10HZ(MAX))
Position accuracy:2M
Acquisition:Cold start 26s ;Hot start 1s;Aided start 2s
Sensitivity Tracking and nav. -167dBMï¼›Cold start Hot star -148dBMï¼›Reacquisition -160dBM
Protocol:UAVCAN
Upgrade firmware:Support
Support Flight control type:Ardupilot/PX4*
Interface Type:GHR-04V-S
Input voltage:4.7~5.2V
Operating temperature:-10~70℃
Size:60mm×60mm×16mm(without stand)
Weight:33g(without stand)

UAV NEO V2 Pro GPS Bus Drone Open Source Flight Control High Precision Positioning Module GNSS
UAV NEO V2 Pro GPS Bus Drone Open Source Flight Control High Precision Positioning Module GNSS
UAV NEO V2 Pro GPS Bus Drone Open Source Flight Control High Precision Positioning Module GNSS
UAV NEO V2 Pro GPS Bus Drone Open Source Flight Control High Precision Positioning Module GNSS
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Friday 30 April, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here