X7 Pixhawk by CUAV PX4 FPV RC Drone multu copter


$418.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
X7 Autopilot
X7® is an advanced autopilot independently designed by CUAV®. It uses a higher-performance STM32H7 processor and integrates industrial-grade sensors and ultra-low temperature drift sensors. Compared with the previous flight controller,it has better performance and more reliability. This board can run ArduPilot firmware perfectly, and it will also be compatible with PX4 firmware. X7 is ideal for academic research and commercial systems integration.
Product Details
Other characteristics
Internal shock absorption
Modular design, can be DIY carrier board
Support USB_HS, download logs faster
Support more dshot output
Support IMU heating, make the sensor work better
Dedicated uavcan battery port
3 sets of IMU sensors
Quick Summary
Main FMU Processor: STM32H743
On-board sensors:
Accelerometer/Gyroscope: ICM-20689
Accelerometer/Gyroscope: ICM-20649
Accelerometer/Gyroscope: BMI088
Magnetometer: RM3100
Barometer: MS5611*2
Interfaces:
14 PWM outputs (12 supports Dshot)
Support multiple RC inputs (SBUs / CPPM / DSM)
Analogue / PWM RSSI input
2 GPS ports(GPS and UART4 ports)
4 i2c buses(Two i2c dedicated ports)
2 CAN bus ports
2 Power ports(Power A is common adc interface, Power C is uavcan battery interface)
2 ADC intput
1 USB ports
Power System:
Power: 4.3~5.4V
USB Input: 4.75~5.25V
Servo Rail Input: 0~36V
Weight: 101 g
Other Characteristics:
Operating temperature: -20 ~ 80°c(Measured value)
Three imus
Supports temperature compensation
Internal shock absorption
Item Packing
X7 Autopilot x 1
12C/CAN cable x 2
ACD3.3 cable x 1
RSSI cable x 1
CAN PMU SE standrd power management module x 1
DuPont cable x 1
Safety switch x 1
Pw-Link module x 1
USB-TypeC cable x 1
16G memory card x 1
Detailed Images
CUAV X7 Pixhawk Open Source Flight Controller for PX4 FPV RC Drone copter
CUAV X7 Pixhawk Open Source Flight Controller for PX4 FPV RC Drone copter
CUAV X7 Pixhawk Open Source Flight Controller for PX4 FPV RC Drone copter
CUAV X7 Pixhawk Open Source Flight Controller for PX4 FPV RC Drone copter
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Sunday 08 November, 2020.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here