4-Pin 50CM Sensor Cable for Gimbal Controller BGC Series


$3.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
- Super soft and thin silicon wires, extremely low resistance to gimbal movements.
Product Details
Wire type: super soft silicon wire
Weight: 2.5g
Wire length: 50cm (approx.)
Pin distance: 1mm
Connector pin numbers: 4-pin to 4-pin
Suitable controllers: BGC series or other controllers using same connectors.
Hint: Due to the design of I2C protocol, it doesn't suit for using long wires, when use this cable, it is suggested to increase the I2C signal level to increase the communication stability as shown in below diagram.
Item Packing
-sensor cable X 1
  • 96 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Tuesday 22 April, 2014.

Customers who bought this product also purchased...


Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here