BGC 32 Storm 32Bit 3Axis Brushless Gimbal Controller V1.31


$45.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
- Processor: STM32F103RC at 72Mhz
- Motor driver: DRV8313 with short circuit, overheat protection
- Onboard gyro and acceleration sensor MPU6050
- IR LED Interface
- Futaba S-BUS
- Spektrum satellite port
- 7CH PWM/Sum-PPM input/output
- Each axis could connect analog joystick
- With I2C port, could use external 6050 to replace onboard sensor
- 3* AUX port
http://www.olliw.eu/storm32bgc-wiki/Main_Page http://www.olliw.eu/storm32bgc-wiki/Getting_Started Product Details
- Power supply: 3S
- Drive current: Max.1.5A
- Dimension: 5-5cm, M3 screw hole, 45mm pitch
- Weight: 10g
Storm 32Bit 3Axis Brushless Gimbal Controller Storm 32Bit 3Axis Brushless Gimbal Controller Storm 32Bit 3Axis Brushless Gimbal Controller
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Wednesday 13 May, 2015.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here