Joystick Controller 3rd Axis Extension Board for Handheld Gimbal


$9.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
Simple Rocker 0.9 is the extension board for Simple Rocker 1.2. Output YAW through left-right control; Output camera signal through up-down control. (Applicable to camera focus and shutter trigger.) When main board assembled with extension board, the output interface is on main board. PMW1 and PMW2 are both output same signal- camera signal. ROLL, PITCH, and YAW are controlled through serial ports. Camera signal is usually turned off. Press the joystick on main board to activate output PWM, and release the joystick to turn it off. Product Details
-Joystick Controller Simple Rocker 1.2 for Handheld Brushless Gimbal (Main Board Only)
Joystick Controller 3rd Axis Extension Board for Handheld Gimbal
  • 99 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Monday 07 April, 2014.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here