CINESTAR 2 Axis Brushless GIMBAL system KIT


$527.04

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
CINESTAR 2 Axis Brushless GIMBAL system KIT
CINESTAR 2 Axis Brushless GIMBAL system KIT
CINESTAR 2 Axis Brushless GIMBAL system KIT
CINESTAR 2 Axis Brushless GIMBAL system KIT
OLD
CINESTAR 2 Axis Brushless GIMBAL system KIT

3-Axis Brushless Camera Gimbal/camera mount/ Stabilized Mount for Multicopter/Octocoter.

2-Axis Brushless Camera Gimbal/camera mount/ Stabilized Mount for Multicopter/Octocoter.
NEW UPDATED 2AXIS BGC GIMBALS with 2 i-flight 5108-120T motor for GH4 camera
Quic release roll bar CF roll motor cage CH tilt motor cage
Included:
1 x MV071 with 1pc GBM5208H-180T
1 x MV061 ADJUSTABLE CAMERA RAIL
1 x MV005 brushless gimbal-2.5mm tilt mount of bearing with locking nut 1set/pack
1 x MV017 updated 4mm thick DUAL ADJUSTABLE TILT BAR 1set
3 x MV027 25mm Boom Connector/T connector/aluminum for 1pc OR CINESTAR freefly NEW TOP BOOM CONNECTOR CS032
1 x MV023 3 axis 4.0mm thickness X motor cage for 5208/5108 motor without motor
1 x MV021 Iflight 5108-120T motor
2 x MV004 brushless gimbal-CARBON FIBER BOOM/TUBE (260MM)
2 x MV002 Brushless gimbal-CARBON FIBER BOOM/TUBE (150MM)
suggest not included: BaseCam Electronics 32Bit Alexmos BGC controller

Suitable for Full Frame Digital Cameras (such as: CANON 5DMark II/5D Mark III, SONY α900, NIKON D800E/D700/D800, etc). Adopts Japan 3K pure carbon fiber plate and 25MM3K hollow pure carbon fiber pipe (none 3K glass fiber pipe) with higher standard than similar products, which belongs to professional Commercial products. The 3-axis gravity of camera mount can be adjusted according to actual demand, besides, the rudder servo can rotate in 360 degrees. All the accessories of tarot multirotor camera mount are lusterless so as to avoid sunlight reflecting caused poor image quality

assembly required for this KIT.
  • 50 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Tuesday 04 June, 2013.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here