G-3S 3-Axis Brushless Gimbal Camera Mount for Sony RX100 II


$430.00

 Sold Out 

  • Description
  • Details
  • Reviews
  • Custom Tab
Walkera G-3S 3-Axis Brushless Gimbal Camera Mount for Sony RX100 II Features
- Smart design and aluminium production
- High precision brushless motor driving control system
- Support Sony RX100 II camera video auxiliary output
- Support power supply voltage compensation
- Support the motor drive end short circuit protection
- Support initial tilt and roll angle custom
- Support stick position mode and rate mode
- Support regular receiver
- Designed to be flown with the QR X800 and Tali H500.
Product Details
- Operating voltage: DC 7.4V--28V(recommended 12V,3S lipo battery)
- Operating current: 600mA-700mA(depebds on the voltage supplied and motor power)
- Operating temperature: -15℃--65℃
- Sensor: 3-axis MEMS gyro and 3-axis MEMS accelerometer
- Control accuracy: 0.02°
- Angle control range: -135°--90°(tilt),-35°--35°(roll)
- Applicable camera: Sony RX100 II
- Size: 134 x 166 x 147mm(LxWxH)
- Weight: 340g(Without camera)
- The controller program can be upgraded on Walkera website(UP02 and UP02 adapter requested)
G-3S 3-Axis Brushless Gimbal Camera Mount for Sony RX100 II
G-3S 3-Axis Brushless Gimbal Camera Mount for Sony RX100 II
G-3S 3-Axis Brushless Gimbal Camera Mount for Sony RX100 II
G-3S 3-Axis Brushless Gimbal Camera Mount for Sony RX100 II
G-3S 3-Axis Brushless Gimbal Camera Mount for Sony RX100 II
  • 0 Units in Stock
  • Manufactured by: Wakera

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Monday 10 November, 2014.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here