Simple BGC Brushless motor with encoder GB106 120T


$265.22

Add to Cart:
Min:  3

  • Description
  • Details
  • Reviews
  • Custom Tab
Simple BGC Brushless motor with encoder GB106 120T special order Express shipping only
AS5048 is an easy to use 360° angle position sensor with a 14-bit high resolution output. The maximum system accuracy is 0.05° assuming linearization and averaging is done by the external micro controller. Used for Yaw motor for simple BGC applications
Special Order, Made to order 2 weeks wait before shipping
almost the same as iflight GB100, GB110 attached a photo of data sheet .
Copper wire (OD):0.3mm Pre-wound with 120 turns.
Internal Resistance:18.8 ohms
NEW BIGGER VERSION OF THIS MOTOR WITH ENCODER BUILT IN PM10025 !
simple BGC encoder GB106
simple BGC encoder motor GB106
simple BGC encoder motor GB106
simple BGC encoder motor GB106
simple BGC encoder motor Data GB106
simple BGC encoder motor Data GB106
Data sheet for BGC encoder
SimpleBGC Encoders how to
  • 97 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Thursday 12 March, 2015.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here