FY-G3 Ultra 3 Axis Brushless Gimbal


Add to Cart:

  • Description
  • Details
  • Reviews
  • Custom Tab
FY-G3 Ultra 3 Axis Brushless Gimbal( for aircraft ) Suitable for GoPro3,GoPro3+ or camera with similar size.Can be easily mounted in fixed wing, multirotor, helicopter for aerial photography, and can work independently only need power supply.
You can assemble the gimbal properly according to the drawing, and then install the video camera on it. The camera mount currently is only suitable for GOPRO3, for other kinds of cameras, you can design the mount by yourself or concern Feiyu Technology,and we will release more camera mount accessories in the near future. There is no need to set up and adjust the parameter. For the first use, power on the Gimbal, and then keep it static for a while, after its reset, the gimbal will be in a level position automatically. Then you can use it normally.
Function Instruction
● Heading Following Mode —— Camera Pitch and Roll angles remain constant, heading follows the nose position, pitch can be control by RC. ● Heading And Pitch Following Mode —— Camera Roll angle remains constant. Heading follow the nose position and Pitch follow the elevation of the aircreft.
● Locking Mode —— Heading, Pitch and Roll are all locked to point at one position.Heading and pitch can be control by RC.
Initialize The FY-G3Ultra Gimbal
FY-G3 Ultra Gimbal needs to be initialized when the following situation appears: 1. After power on, the angle of pitch has a little angle difference with the horizon line.
2. After power on, the angle of roll has a little angle difference with the horizon line.
3. When the heading is in the till condition, the angle of heading amends frequently in a small angle .
【 The method of initializing the FY-G3 Ultra Gimbal 】
Keep the gimbal in the still condition, then power on , it will initialize automatically.After that the gimbal can work normally.
FY-G3 Ultra 3 Axis Brushless Gimbal
FY-G3 Ultra 3 Axis Brushless Gimbal
FY-G3 Ultra 3 Axis Brushless Gimbal
FY-G3 Ultra 3 Axis Brushless Gimbal
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

This product was added to our catalog on Tuesday 12 August, 2014.



Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.

your alt text here