G-2D Brushless Gimbal for iLook/Gopro Hero 3/Sony (Plastic)



$115.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Walkera G-2D Brushless Gimbal for iLook/Gopro Hero 3/Sony (Plastic)
Features
THIS IS THE PLASTIC VERSION OF GIMBLE .!!!!
Designed in high intensive,light and agility, easy to use Support super stable aerial photography
Support iLook /Gopro Hero3/Sony Camera
Support 350 size and above drones to shooting videos
Support the GOPRO Hero3 video aux output
Support the power supply voltage reverse connection protection and voltage compensation
Support for motor drive side short circuit protection
Support initial pitch angle
Support the sensitivity parameters adjustment and the software 3d posture
display
Product Details
Brand Name: Walkera
Item Name: G-2D gimbal
Size: 3.9 x 3.7 x 3.3 inches
Operating voltage: 7.4V ~ 14.8V DC (recommended 12 V, 3S lipo battery)
Work current: 200 mA - 500 mA
Working environment temperature: -15-65C
Sensors: three MEMS gyroscope rotor and rotor MEMS accelerometer
Maximum angular rate: 2000 deg/ SEC
Maximum acceleration: 16g
Control frequency: 1000 Hz
Motor drive frequency: 32 kHZ (noiseless smooth drive)
Accuracy: 0.1 deg
Control Range:-45~45(Roll) -135~90(Pitch)
Applicable filming equipment: GOPRO Hero3
Item Packing
-Walkera G-2D Brushless Camera Gimbal Plastic Version
Detailed Images
G-2D Brushless Gimbal for iLook/Gopro Hero 3/Sony (Plastic)
G-2D Brushless Gimbal for iLook/Gopro Hero 3/Sony (Plastic)
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Wednesday 02 July, 2014.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here