G-3D Brushless 3 Axis Camera Gimbal for Gopro iLook Camera FPV


$172.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
- Simple operation, more stable for video shooting
- Smart design, aluminium built
- High precision brushless motor driving control system
- High precision, hyper stable designed for aerial photography or video shooting
- Designed in high intensive, light and agility, easy to use, just plug and play
- Perfectly support iLook, iLook+, GoPro HERO3, GoPro HERO3+ camera
- Support 350 size and above aircraft
- Power voltage compensation available
- Support motor drive side short circuit protection
- Support initial roll and tilt customed
- Support stick rate mode and position mode
- Regular receiver accepted
- Support online firmware upgrade (UP02 and UP02 adapter required)
Product Details
- Operating voltage: 2S-6S LiPo (7.4V-26V)
- Static current: 350mA (@12V)
- Dynamic current: 350-600mA (@12V)
- Pitch control angle: -130° - +90°
- Roll control angle: -45° - +45°
- Weight: 175g (without camera)
- Dimension: 95*94*75mm
G-3D Brushless 3 Axis Camera Gimbal for Gopro iLook Camera FPV


  • 100 Units in Stock
  • Manufactured by: Wakera

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Tuesday 12 August, 2014.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here