Zenmuse H3-3D 3-axis Brushless Gimbal + DJI Phantom 2


$980.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Zenmuse H3-3D 3-axis high performance Brushless Gimbal + DJI Phantom 2
Features
-The Phantom 2 is unbelievably easy to fly. Combined with smooth, stabilised footage from theH3-3D gimbal, aerial cinematography and videography has never been easier. It’s light, rugged and perfect for travel.
-Precision Flight and Stable Hovering
-25min Flight Time & Intelligent Battery
-Auto Return-to-Home & Landing
-Advanced Power Management
-Intelligent Orientation Control (IOC)
-Easy Battery Replacement
-Self-tightening Propeller
-Video Downlink Support
-CAN-Bus Expansion Module
-3-axis high performance gimbal
-Effortless Setup
-Compatible with DJI flight control systems
-Part of the Zenmuse family
-Independent IMU
-Online Upgrade
Product Details
-Supported Camera:GoPro3, GoPro3+ Black and Sliver
-GCU Input Power:3S~6S LiPo (12V~26V)
-Assistant Software System Requirement:Windows XP SP3; Windows 7; Windows 8
-Gimbal Operating Current
-Static current: 400mA (@12V)
-Dynamic current: 600mA (@12V)
-Gimbal Input Power:3S~6S (12V ~ 26V)
-Operating Temperature:-10°C ~ 50°C
-Gimbal Weight:168g (camera excluded)
-Gimbal Dimensions (With Damping Unit):97mm X 95mm X 73mm
-GCU Weight:22g
-GCU Dimensions:42 mm X 32 mm X 9.3 mm
-Controlled Angle Accuracy:Tilt/Roll: ±0.02°; Yaw: ±0.03°
-Maximum Controlled Rotation Speed:Tilt axis: ±130°/s
-Controlled Rotation Range:Tilt axis control: -130 ~ +45°
Zenmuse H3-3D 3-axis Brushless Gimbal + DJI Phantom 2
Zenmuse H3-3D 3-axis Brushless Gimbal + DJI Phantom 2
Zenmuse H3-3D 3-axis Brushless Gimbal + DJI Phantom 2
Zenmuse H3-3D 3-axis Brushless Gimbal + DJI Phantom 2
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Tuesday 01 April, 2014.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here