AERIAL 3axis 360 degrees brushless gimbal for cinestar copter


$1,400.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
full Cinestar compatible 3 axis 360 degrees in all axis, brushless gimbal AERIAL version compatible with all cinestar accessory and parts. Quick release Roll And pitch attachment also available with larger motors. Express shipping only we ship world wide DHL FedEx.
ALL CARBON FIBER FRAME 4mm thick, 25mm cf tube, thumb screws on camera tray adjustment and thumb screws on Pitch Roll axis attachment. did you know you can invert the YAW and use your landing gear as a tripod turning your gimbal into a remote 360 camera 2.5 foot hiy 10 cm wheels not included camera not included. available as kit you as a kit you assemble or RTF this lot is for kit you assemble your self.
3 x motor cages
3 x encoder motors PM5208 with AS5600
3 x 6 wire slip ring
3 x landing gear legs
3 x landing gea leg tips
1 gimbal frame
payload up to 12lb tiny pro config 14v battery
waight 5lb
recommended choice of controller:
. https://www.basecamelectronics.com/downloads/32bit/#latest
. Simple BGC 32-bit CAN_MCU 3 CAN Driver kit
GPS IMU connects to any free UART port of the main controller
SimpleBGC 32bit Extended main board CAN_Driver Kit
tiny pro BGC cameA IMU CONTROLLER IMU
max voltage 23v
Gimbal frame only and motors
not included :
BGC
Battery
wheels
Handle Bar YAW axis for hand held
AERIAL 3 axis 360 degrees brushless gimbal
AERIAL 3 axis 360 degrees brushless gimbal
AERIAL 3 axis 360 degrees brushless gimbal
AERIAL 3 axis 360 degrees brushless gimbal
AERIAL 3 axis 360 degrees brushless gimbal
AERIAL 3 axis 360 degrees brushless gimbal
AERIAL 3 axis 360 degrees brushless gimbal
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Wednesday 10 July, 2019.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here