AlexMos 32 BIT BGC with Encoder Motor kit iflight-rc GBM110-1


$620.84

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
AlexMos 32 BIT BGC with Encoder Motor Set GBM110-150T
Descriptions:
Encoders are special sensors that are added to each brushless motor of a Gimbal Stabilizer allowing the system to more accurately track motor position for increased stability which in turn also increases battery efficiency.
Specs: -Copper wire (OD):0.32mm Pre-wound with 150 turns.
-Internal Resistance:17.8 ohms
-Motor Can Dimension:110mm(OD) x 26mm(Height)
-Stator Dimension:100mm(OD) x 8mm(Height)
-Configuration:24N28P
-Wire length:450mm including JR plug
-Camera size:5kg-8kg
-Weight:554grams
Features:
- Easy to do gimbal tuning,no need to do much calibration work any more.
- Power saving, 5 times long working time than gimbal without encoder system.
- ONLY ONE IMU,no need camera frame.
- Faster response,motor torque increasing instantly,no bug for difficult rotating angle any more.
Package Included option 1:
- 3 x GBM110-150T motor
- 3 x AS5048A encoder chips with CNC alum cover
- 3 x Round magnets block
- 1 x Pre-flashed encoder firmware alexmos 32BIT BGC set
AlexMos 32 BIT BGC with Encoder Motor Set
AlexMos 32 BIT BGC with Encoder Motor Set
AlexMos 32 BIT BGC with Encoder Motor Set
AlexMos 32 BIT BGC with Encoder Motor Set
  • 99 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Friday 20 May, 2016.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here