BGC encoder 3 motor GBM4108H-120T & AlexMos 32 BIT combo


$340.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Descriptions:
Encoders are special sensors that are added to each brushless motor of a Gimbal Stabilizer allowing the system to more accurately track motor position for increased stability which in turn also increases battery efficiency. The 3 axis stabilization gimbal system that relies on both active motor driven components and passive inertial stabilization. Passive stabilization relies on the principles of inertia (tendency of an object to resist change in its motion) and requires that the camera is well-balanced in the Pan, Tilt, and Roll Axes. Active stabilization refers to the techniques of using sensors to measure the camera’s Pan, Tilt, and Roll movements and counteract those movements using motors attached to the 3 axes.
Features:
- Easy to do gimbal tuning,no need to do much calibration work any more.
- Power saving, 5 times long working time than gimbal without encoder system.
- Twin IMUs.
- Faster response,motor torque increasing instantly,no bug for difficult rotating angle any more.
- Encoder chip A5048a
Package included:
- 3 x GBM2804H-120T Brushless Gimbal with AS5048A Encoder & Magnet
- 1 x Pre-flashed encoder firmware alexmos 32BIT BGC set
Connecting encoders to the regular SimpleBGC 32bit board
BGC encoder 3 motor GBM4108H-120T & AlexMos 32 BIT combo
BGC encoder 3 motor GBM4108H-120T & AlexMos 32 BIT combo
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Thursday 09 March, 2017.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here