BGC Encoder Motor DM50 with slip ring



Starting at: $75.99

Please Choose:



Encoder




Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
1 x BGC AS5600 Encoder Motor DM50-10 with optional slip ring , 3kg payload- single motor . Expresses shipping only by DHL
ii12c encoder connection & BGC connection between the three motors 3 axes and the connection with the IMU uses ii2c bus connection, mother board and BGC driver board module, IMU model. Connection Block uses JST standard standard 5 pin connector connection, easy to connect slip ring, wiring simple, easy assembly and maintain. The center of each board has a 12-bit encoder, the motor is ready for encoder firmware. Board voltage 2s-4s lithium battery.
RMD motor datasheet
RMD-S servo motor instruction V1.5
3 kg payload
Motor Dimensions 88x29.9mm
Weight 170g
Stator Dimension 49x33.5mm
Configuration 24N28P
copper Wire .30mm
Winding Type WYE
Max Normal Voltage 10.5-21V
Resistance 13.20
max current 2.5A
hollow diameter 12.6
max weight 0.8kg
Max Stall current 3
Diameter of Hollow shaft 8.1mm
RMD motor datasheet
RMD-S servo motor instruction V1.5
BGC Encoder Motor DOC DM 50-10 motor
BGC Encoder Motor DOC DM 50-15 motor
BGC Encoder Motor DOC DM 50-5 motor
DM BGC Encoder MOTOR Documentation
ii2c Encoder Motor doc
BGC AS5600 Encoder Motor DM50-15 with slip ring 3kg payload
BGC AS5600 Encoder Motor DM50-15 with slip ring 3kg payload
BGC AS5600 Encoder Motor DM50-15 with slip ring 3kg payload
BGC AS5600 Encoder Motor DM50-15 with slip ring 3kg payload
  • 98 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Monday 26 June, 2017.

Customers who bought this product also purchased...


Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here