BGC Encoder Motor DM90-130T SlipRing 10kg Payload BGC controller


Starting at: $319.99

Please Choose:



Encoder




Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Express shipping only for this product : 1 x BGC AS5600 Encoder Motor DM90-130T with slip ring & 1 Basecam Electronics BGC Encoder PCB built in to the motor DM90-130T, 10kg payload
i2c encoder connection & BGC connection between the three motors 3 axes and the connection with the IMU uses ii2c bus connection, mother board and BGC driver board module, IMU model. Connection Block uses JST standard standard 5 pin connector connection, easy to connect slip ring, wiring simple, easy assembly and maintain. The center of each board has a 12-bit encoder, the motor is ready for encoder firmware. Board voltage 2s-4s lithium battery. RMD motor datasheet
RMD-S servo motor instruction V1.5
BGC AS5048B Encoder Motor DM90-130T with slip ring 
This is for a set of 3 DM90-130T BGC GIMBAL Motor
10kg payload
Motor Dimensions 88x29.9mm
Weight 430g
Stator Dimension 80x10mm
Configuration 24N28P
copper Wire .30mm
Turns 130
Winding Type WYE
Max Normal Voltage 25V
Resistance Ri Qhm 17
idle current@10V 90mA
Max Stall current 3
Diameter of Hollow shaft 12.55mm
Stator mounting pitch size 58mm, 4xM4
Rotor mounting 30mm, 4xM4, 35mm, 4xM4
max weight 10kg
DM BGC AS5048B Encoder MOTOR Documentation
DM 90-10 BGC motor specification
DM 90-15 BGC motor specification
BGC AS5600 Encoder Motor DM90-130T with slip ring 10kg payload
BGC AS5600 Encoder Motor DM90-130T with slip ring 10kg payload
BGC AS5600 Encoder Motor DM90-130T
BGC AS5600 Encoder Motor DM90-130T
BGC AS5600 Encoder Motor DM90-130T
BGC AS5600 Encoder Motor DM90-130T
BGC AS5600 Encoder Motor DM90-130T
  • 96 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Wednesday 07 June, 2017.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here