BaseCam 32-Bit 3-Axis BGC 3 x PM2205 encoder version Revision B




$399.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
SimpleBGC 32bit small Rev. B: main board X 1pc + I2C
IMU sensor board X 1pc + I2C IMU 45cm wire X
3pc PM2205 motor gimbal X
3pcs AS5048a encoder with hollow magnet X 1pc
Product Details
BGC Specifications
Board size: 40×25mm
Distance between mounting holes: 23×19mm
Power supply voltage: 3.7-25V (1s 6s LiPo)
Max motor current : 1A
Description:
Built-inI2C IMU sensor can be used as a second sensor or the main sensor.
Possibility to adjust the voltage from 6 to 11 V and to connect
small motors despite the current of a battery.
Has the same sockets as the full-size 32-bit SimpleBGC.
Possibility to connect the optional Bluetooth module.
Improvements:
Smaller than the previous version: Dimensions are 25×40mm
Current capabilities have been expanded:
The +5V line can supply up to 1A of continuous current
(it's enough to power the GoPro camera), and up to 2A of instantaneous current
The +3.3V line can supply up to 500mA of continuous current and 1a of
instantaneous current The input voltage range has been extended to 1s 6s (3.7V-25V)
USB-UART onboard converter simplifies the PC connection, fewer
problems with drivers compared to the previous version
PM2205-BGC-kit
BaseCam 32-Bit SimpleBGC 3-Axis Gimbal Controller Small Revision B Control with Encoder and 3xPM2205 BLDC Gimbal Motor
BaseCam 32-Bit SimpleBGC 3-Axis Gimbal Controller Small Revision B Control with Encoder and 3xPM2205 BLDC Gimbal Motor
BaseCam 32-Bit SimpleBGC 3-Axis Gimbal Controller Small Revision B Control with Encoder and 3xPM2205 BLDC Gimbal Motor
BaseCam 32-Bit SimpleBGC 3-Axis Gimbal Controller Small Revision B Control with Encoder and 3xPM2205 BLDC Gimbal Motor
BaseCam 32-Bit SimpleBGC 3-Axis Gimbal Controller Small Revision B Control with Encoder and 3xPM2205 BLDC Gimbal Motor
BaseCam 32-Bit SimpleBGC 3-Axis Gimbal Controller Small Revision B Control with Encoder and 3xPM2205 BLDC Gimbal Motor
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

Product 6/97

 Prev 
 All 
 Next 

This product was added to our catalog on Saturday 07 May, 2022.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here