High Efficiency 30A Microprocessor Discharger LCD Display PROLUX


$120.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
1. 12 bits microprocessor design
2. Multi type battery packs Discharger, Buzzer and Voltmeter
3. Large power 200W brings high performance
4. Two-line 16 characters dot matrix large LCM display
5. Includes an advanced temperature sensor. The discharger will stop
discharge automatically when the temperature is over 70?C
7. Discharge capacity can go up to 99900mAh
8. Voltmeter function can read voltage accurately
9. Li-series battery packs can detect each single cell
voltage and resistance through balance port
Product Details
Input: DC 5.4 - 35V
Battery Type: Ni-Cd / Ni-MH / Li-Po / Li-HV / LiFePo / Pb
Battery Cell: Ni-Cd/Ni-MH 6 – 30 Cell (5.4V –35.0V)
Li-Po/Li-HV 2 – 8 Cell, LiFePo 3 – 8 Cell
Pb 5.4V, 10.8V, 21.6V
Discharge Rate: 1 - 30A (0.1A Per gradation)
PROLUX-3015
High Efficiency 30A Microprocessor Discharger w/LCD Display PROLUX For RC Model #3015
PROLUX High Efficiency 30A Microprocessor Discharger w/LCD Display For RC Model #3015
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

Product 27/96

 Prev 
 All 
 Next 

This product was added to our catalog on Friday 17 December, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here