ToolkitRC M8 Battery 300w 15A Charger, Cell checker, Servo Test


$59.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
Battery Charger
Cell Checker
Servo Tester
PWM,PPM.SBUS Input/output Receiver & Flight control tester
Viable AMp/volt DC Power supply (Required external DC input)
Product Details
Specs
● Charge, discharge and balance management support LiPo, LiHV, LiFe 1-8S,NiMh 1-20S,PB 1-12S battery.
● Charger current:MAX 15A @ 300W
● Discharge current:reccycle mode 15A @ 300W Normal: 3A @ 20W
● Balance current: 400mA @ 2-8S
● Lithium battery cut-off voltage can be set (TVC function)
● Measure battery voltage, internal resistance, balance
● ESC power meter, together with output voltage and throttle signal
● Measure PWM / PPM / xBUS signal values, Accuracy 1ms
● Output PWM / PPM / xBUS standard signal, Accuracy 1ms
● Customizable 5-30V constant voltage, 1-15A constant current
● Charge the drone battery, activate and charge.
● Multi-language optional
● USB 2.1A@5.0V Output,for Mobile devices
● Udisk firmware upgrade (Slave device)
Charger
Input voltage: 7.0-30.0V @MAX 16A
Type of battery: Lipo LiHV LiFe @1-8S
NiMh @1-20S Pb @1-10S
Balance current: 400mA @2-8S
Charge power: 300W @MAX 15A
Discharge power: 300W @MAX 15A Recycle mode
12W @ 3A Normal mode
USB: 2.1A @5.0V or Upgrade
Dimensions: 98*68*35 mm
Weight: 142g
LCD: 2.2inch, 132*64 Pixel,black and white
Measurement
PWM: 880-2200us @20-400Hz
PPM: 880-2200us*8CH @20-50Hz
SBUS: 880-2200us*16CH @20-100Hz
Voltage: 1.0-5.0V @1-8S
IR: 10-500mR @1-8S
ESC: 300W @Max 15A
Output
PWM: 880-2200us @20-400Hz
PPM: 880-2200us*8CH @20-50Hz
SBUS: 880-2200us*16CH @20-100Hz
Power: 1.0-30.0V @1.0-15A Mode:CC+CV
OverCurrent Cut Off time: 50ms
ToolkitRC M8 Battery 300w 15A Charger, Cell checker, Servo Test
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Monday 07 January, 2019.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here