UltraPower UP7 AC200W DC400W 10Ax2 Dual Channel Balance Charger


$139.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
UltraPower UP7 AC200W DC400W 10A x 2 Dual Channel Balance
Charger Discharger for Lipo LiHV Lilon LiFe RC Models Battery
AC / DC TWO Channels Support AC or DC Input, meet different needs,
output power is 200W in AC mode,400W in DC mode
2.4'' High-definition IPS colorful screen
all the data are visible under the sunshine , easy to get the information
Dual channel output, higher efficiency
Independent dual channel output, without interference by each other,
single channel current up to 10.0A, support to charge 2pcs different type
batteries simultaneously. Including Lipo, LIHV, Lilon, Life, Nimh, Nicd, Lead Acid.
Product Details
Input Voltage: AC 100-240V , DC 9.0-32.0V
Output Voltage: 0.1-30.0V
Charging Current: 0.1-10.0A x 2
Discharge Current
• CH1: 0.1-2.0A / 0.1-15.0A ( External discharge mode)
• CH2: 0.1-2.0A
Charge Powe
• DC Input: 2 x 200W
• AC Input: Max 200W (CH1 + CH2 = 200W)
• Support power distribution
Discharge Power
• CH1: 6W / 200W (External discharge mode)
• CH2 : 6W
Balance Current: Max.1000mA / cell
Support Battery Types:
• Lipo / LIHV / Life / Lilon (1-6S)
• NIMH / Nicd (1-16s)
• Lead Acid 2V-24V (1-12S)
LCD Screen type: 24'' 320X240 IPS LCD
Dimensions: 100 x 199 x 64mm
Weight: 450g
LC-UP7
UltraPower UP7 AC200W DC400W 10A x 2 Dual Channel Balance Charger Discharger for Lipo LiHV Lilon LiFe RC Models Battery
UltraPower UP7 AC200W DC400W 10A x 2 Dual Channel Balance Charger Discharger for Lipo LiHV Lilon LiFe RC Models Battery
UltraPower UP7 AC200W DC400W 10A x 2 Dual Channel Balance Charger Discharger for Lipo LiHV Lilon LiFe RC Models Battery
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Tuesday 28 June, 2022.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here