4KW mid drive QS138 motor kit with ESC, 72V 200A 110km/h


$823.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
QS 138 4KW mid drive motor kit, 72V 110km/h.
E-motorcycle weight about: 130kg+2*80kg
Speed: Continuous 100KPH
Climbing slope: 30°@208KGS
Battery: 72V52ah
Tire: 130/70-17
Product Details
110kmh Peak 10KW QS138 90H 4KW Mid Drive Motor
200A ESC Sine Wave Controller Peak Phase Current: 600A
1pc x QS138 4KW mid drive motor (belt or sprocket type)
1pc x Votol EM200 Controller with USB Cable
1pc x Twist throttle hall type
Motor type: PMSM motor with Hall sensor
Rated power: 7500W (13500W peak in seconds)
Rated voltage: 72V
Speed: 4000RPM (base RPM), 6500RPM peak with flux damping
Motor design: single axis
Matching tire: 17 inches
Magnet height: 90mm, 5 pole pairs
Nominal torque: 14.3 n. m
Maximum torque: 72N.m
Maximum efficiency: about 94%
Battery continuous current: 89A (72V) Battery
peak current: 200A (72V)
Operating temperature: 70-120℃, peak 150℃
Single Hall assembly with waterproof connector Waterproof
category: IP67
Cooling: Fresh air
Phase wire: 20 mm²
Color: Black
N.W./GW: about 13.5kg/15kg
Dimensions: 34cm*34cm*33cm
QS138 4KW
QS138 4KW mid drive motor kit, 72V 200A 110km/h
QS138 4KW mid drive motor kit, 72V 200A 110km/h
QS138 4KW mid drive motor kit, 72V 200A 110km/h
QS138 4KW mid drive motor kit, 72V 200A 110km/h
QS138 4KW mid drive motor kit, 72V 200A 110km/h
4KW mid drive QS138 motor kit with ESC, 72V 200A 110km/h
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Sunday 15 May, 2022.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here